device_is_attached (9)

Leading comments

Copyright (c) 1998 Doug Rabson

All rights reserved.

This program is free software.

Redistribution and use in source and binary forms, with or without
modification, are permitted provided that the following conditions
are met:
1. Redistributions of source code must retain the above copyright
   notice, this list of conditions and the following disclaimer.
2. Redistributions in binary form must reproduce the above copyright
   notice, this list of conditions and the following disclaimer in...

(The comments found at the beginning of the groff file "man9/device_is_attached.9freebsd".)

NAME

device_get_state device_busy device_unbusy device_is_alive device_is_attached - manipulate device state

SYNOPSIS

In sys/param.h In sys/bus.h Ft device_state_t Fn device_get_state device_t dev Ft void Fn device_busy device_t dev Ft void Fn device_unbusy device_t dev Ft int Fn device_is_alive device_t dev Ft int Fn device_is_attached device_t dev

DESCRIPTION

The current state of a device is accessed by calling Fn device_get_state which returns DS_NOTPRESENT DS_ALIVE DS_ATTACHED or DS_BUSY (described in device(9)). To test see if a device was successfully probed, call Fn device_is_alive which simply returns if the state is greater or equal to DS_ALIVE To test see if a device was successfully attached, call Fn device_is_attached which simply returns if the state is greater or equal to DS_ATTACHED

Each device has a busy count which is incremented when Fn device_busy is called and decremented when Fn device_unbusy is called. Both routines return an error if the device state is less than DS_ATTACHED

When Fn device_busy is called on a device in the DS_ATTACHED state, the device changes to the DS_BUSY state. When Fn device_unbusy is called and after decrementing, the busy count for the device is zero, the device changes to the DS_ATTACHED state.

SEE ALSO

device(9)

AUTHORS

This manual page was written by An Doug Rabson .