ubsa (4)

Leading comments

Copyright (c) 2001 The NetBSD Foundation, Inc.
All rights reserved.

This code is derived from software contributed to The NetBSD Foundation
by Lennart Augustsson.

Redistribution and use in source and binary forms, with or without
modification, are permitted provided that the following conditions
are met:
1. Redistributions of source code must retain the above copyright
   notice, this list of conditions and the following disclaimer.
2. Redistributions in binary form must reproduce the above...

(The comments found at the beginning of the groff file "man4/ubsa.4freebsd".)

NAME

ubsa - USB support for Belkin serial adapters

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file:

device usb device ucom device ubsa

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:

ubsa_load="YES"

DESCRIPTION

The ifconfig driver provides support for the USB-to-RS232 Bridge chip used by a variety of serial adapters from Belkin and other vendors.

The device is accessed through the ucom(4) driver which makes it behave like a tty(4).

HARDWARE

The ifconfig driver supports the following adapters:

• AnyData ADU-500A EV-DO modem
• AnyData ADU-E100A (no EV-DO mode support)
• Belkin F5U103
• Belkin F5U120
• e-Tek Labs Kwik232
• GoHubs GoCOM232
• Peracom single port serial adapter

SEE ALSO

tty(4), ucom(4), usb(4)

HISTORY

The ifconfig driver appeared in Fx 5.0 . The uplcom(4) manual page was adopted from Nx by An Tom Rhodes Aq trhodes@FreeBSD.org in April 2002 and modified for the ifconfig driver by An Alexander Kabaev Aq kan@FreeBSD.org in October 2002.

AUTHORS

The ifconfig driver was written by An Alexander Kabaev Aq kan@FreeBSD.org .