ixlv (4)

Leading comments

Copyright (c) 2013-2015, Intel Corporation
All rights reserved.

Redistribution and use in source and binary forms, with or without
modification, are permitted provided that the following conditions are met:

 1. Redistributions of source code must retain the above copyright notice,
    this list of conditions and the following disclaimer.

 2. Redistributions in binary form must reproduce the above copyright
    notice, this list of conditions and the following disclaimer in the
    document...

(The comments found at the beginning of the groff file "man4/ixlv.4freebsd".)

NAME

ixlv - Intel XL710 Ethernet 40Gb VF driver

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file:

device ixlv

To load the driver as a module at boot time, place the following lines in loader.conf5:

if_ixlv_load="YES"

DESCRIPTION

The driver provides virtualization support for PCI Express adapters or LOMs in the XL710 Family of ethernet devices. The driver supports Jumbo Frames, TX/RX checksum offload, TCP segmentation offload (TSO), Large Receive Offload (LRO), VLAN tag insertion/extraction, VLAN checksum offload, VLAN TSO, and Receive Side Steering (RSS), all for both IPv4 and IPv6. For further hardware information and questions related to hardware requirements, see support.intel.com

Support for Jumbo Frames is provided via the interface MTU setting. Selecting an MTU larger than 1500 bytes with the ifconfig(8) utility configures the adapter to receive and transmit Jumbo Frames. The maximum MTU size for Jumbo Frames is 9706.

Offloads are also controlled via the interface, for instance, checksumming for both IPv4 and IPv6 can be set and unset, TSO4 and/or TSO6, and finally LRO can be set and unset.

For more information on configuring this device, see ifconfig(8).

NOTE The driver is only used by means of SRIOV, normally in a VM on a hosting server with the ixl(4) driver.

LOADER TUNABLES

Tunables can be set at the loader(8) prompt before booting the kernel or stored in loader.conf5.

hw.ixlv.ringsz

Set the number of descriptors in the rings, note that this changes BOTH the TX and RX rings, they cannot be set independently.

hw.ixlv.max_queues

Set the number of queues (each a TX/RX pair) for the port, this allows one to override the autocalculation if it is set to 0.

hw.ixlv.txbrsz

Set the size of the buff ring used by the transmit side of the stack, we have found that it is necessary to have it quite large in order to get UDP to perform well.

hw.ixlv.dynamic_rx_itr

The dynamic RX interrupt control, set to 1 to enable, off by default.

hw.ixlv.dynamic_tx_itr

The dynamic TX interrupt control, set to 1 to enable, off by default.

hw.ixlv.rx_itr

The RX interrupt rate value, set to 8K by default.

hw.ixlv.tx_itr

The TX interrupt rate value, set to 4K by default.

SUPPORT

For general information and support, go to the Intel support website at: support.intel.com

If an issue is identified with this driver with a supported adapter, email all the specific information related to the issue to Aq freebsd@intel.com .

SEE ALSO

arp(4), ixl(4), netintro(4), ng_ether4, vlan(4), ifconfig(8)

HISTORY

The device driver first appeared in Fx 10.1 .

AUTHORS

An -nosplit The driver was written by An Jack Vogel Aq Mt jfv@FreeBSD.org and An Eric Joyner Aq Mt ricera10@gmail.com .