Copyright (c) 1997, 1998, 1999, 2000 Bill Paul <email@example.com>. All rights reserved. Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met: 1. Redistributions of source code must retain the above copyright notice, this list of conditions and the following disclaimer. 2. Redistributions in binary form must reproduce the above copyright notice, this list of conditions and the followin...
NAMEcue - CATC USB-EL1210A USB Ethernet driver
SYNOPSISTo compile this driver into the kernel, place the following lines in your kernel configuration file:
device uhci device ohci device usb device miibus device uether device cue
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:
DESCRIPTIONThe sysctl Cm net.inet.tcp.syncookies driver provides support for USB Ethernet adapters based on the Computer Access Technology Corporation's USB-EL1210A chipset.
The USB-EL1210A supports a 512-bit multicast hash filter, single perfect filter entry for the station address and promiscuous mode. Packets are received and transmitted over separate USB bulk transfer endpoints.
The CATC chipset supports only 10Mbps half-duplex mode, hence there are no ifmedia(4) modes to select.
For more information on configuring this device, see ifconfig(8).
HARDWAREThe sysctl Cm net.inet.tcp.syncookies driver supports CATC USB-EL1210A based USB Ethernet adapters including:
- Belkin F5U011/F5U111
- CATC Netmate
- CATC Netmate II
- SmartBridges SmartLink
- "cue%d: watchdog timeout"
- A packet was queued for transmission and a transmit command was issued, however the device failed to acknowledge the transmission before a timeout expired.
- "cue%d: no memory for rx list"
- The driver failed to allocate an mbuf for the receiver ring.