atse (4)

Leading comments

-
 Copyright (c) 2013-2014 SRI International
 All rights reserved.

 This software was developed by SRI International and the University of
 Cambridge Computer Laboratory under DARPA/AFRL contract (FA8750-10-C-0237)
 ("CTSRD"), as part of the DARPA CRASH research programme.

 Redistribution and use in source and binary forms, with or without
 modification, are permitted provided that the following conditions
 are met:
 1. Redistributions of source code must retain the above copyright
    noti...

(The comments found at the beginning of the groff file "man4/atse.4freebsd".)

NAME

atse - driver for the Altera Triple-Speed Ethernet MegaCore

SYNOPSIS

device atse options ATSE_CFI_HACK

In /boot/device.hints hint.atse.0.at=nexus0 hint.atse.0.maddr=0x7f007000 hint.atse.0.msize=0x540 hint.atse.0.rc_irq=1 hint.atse.0.rx_maddr=0x7f007500 hint.atse.0.rx_msize=0x8 hint.atse.0.rxc_maddr=0x7f007520 hint.atse.0.rxc_msize=0x20 hint.atse.0.tx_irq=2 hint.atse.0.tx_maddr=0x7f007400 hint.atse.0.tx_msize=0x8 hint.atse.0.txc_maddr=0x7f007420 hint.atse.0.txc_msize=0x20 hint.e1000phy.0.at=miibus0 hint.e1000phy.0.phyno=0

DESCRIPTION

The device driver provides support for the Altera Triple-Speed Ethernet MegaCore.

HARDWARE

The current version of the driver supports the Ethernet MegaCore as described in version 11.1 of Altera's documentation when the device is configured with internal FIFOs.

MAC SELECTION

The default MAC address for each interface is derived from a value stored in cfi(4) flash. The value is managed by the atsectl(8) utility.

Only a single MAC address may be stored in flash. If the address begins with the Altera prefix 00:07:ed and ends in 00 then up to 16 addresses will be derived from it by adding the unit number of the interface to the stored address. For other prefixes, the address will be assigned to atse0 and random addresses will be used for other interfaces. If the stored address is invalid, for example all zero's, multicast, or the default address shipped on all DE4 boards (00:07:ed:ff:ed:15) then a random address is generated when the device is attached.

SEE ALSO

miibus(4), netintro(4), ifconfig(8)

Triple-Speed Ethernet MegaCore Function User Guide November 2011

HISTORY

The device driver first appeared in Fx 10.0 .

AUTHORS

The device driver and this manual page were developed by SRI International and the University of Cambridge Computer Laboratory under DARPA/AFRL contract (FA8750-10-C-0237) (Do CTSRD Dc , ) as part of the DARPA CRASH research programme. This device driver was written by An Bjoern A. Zeeb .

BUGS

The driver only supports a single configuration of the MegaCore as installed on the Terasic Technologies Altera DE4 Development and Education Board.

Only gigabit Ethernet speeds are currently supported.