Config::Model::models::LCDd::picolcd (3)

Leading comments

Automatically generated by Pod::Man 4.07 (Pod::Simple 3.32)

Standard preamble:
========================================================================

(The comments found at the beginning of the groff file "man3/Config::Model::models::LCDd::picolcd.3pm".)

NAME

Config::Model::models::LCDd::picolcd - Configuration class LCDd::picolcd

DESCRIPTION

Configuration classes used by Config::Model

generated from LCDd.conf

Elements

Backlight

Sets the initial state of the backlight upon start-up. Optional. Type boolean. upstream_default: 'on'.

Brightness

Set the initial brightness . Works only with the 20x4 device. Optional. Type integer. upstream_default: '1000'.

Contrast

Set the initial contrast Optional. Type integer. upstream_default: '1000'.

Key0Light

If Keylights is on, the you can unlight specific keys below: Key0 is the directional pad. Key1 - Key5 correspond to the F1 - F5 keys. There is no for the +/- keys. This is a handy way to indicate to users which keys are disabled. Optional. Type boolean. upstream_default: 'on'.

Key1Light

Optional. Type uniline. default: 'on'.

Key2Light

Optional. Type uniline. default: 'on'.

Key3Light

Optional. Type uniline. default: 'on'.

Key4Light

Optional. Type uniline. default: 'on'.

Key5Light

Optional. Type uniline. default: 'on'.

KeyRepeatDelay

Key auto repeat is only available if the picoLCD driver is built with libusb-1.0. Use KeyRepeatDelay and KeyRepeatInterval to configure key auto repeat.

Key auto repeat delay (time in ms from first key report to first repeat). Use zero to disable auto repeat. Optional. Type integer. upstream_default: '300'.

KeyRepeatInterval

Key auto repeat interval (time in ms between repeat reports). Only used if KeyRepeatDelay is not zero. Optional. Type integer. upstream_default: '200'.

KeyTimeout

KeyTimeout is only used if the picoLCD driver is built with libusb-0.1. When built with libusb-1.0 key and data is input asynchronously so there is no need to wait for the data. KeyTimeout is the time in ms that LCDd spends waiting for a key press before cycling through other duties. Higher values make LCDd use less time and make key presses more detectable. Lower values make LCDd more responsive but a little prone to missing key presses. 500 (.5 second) is the default and a balanced value. Optional. Type integer. upstream_default: '500'.

Keylights

Light the keys? Optional. Type boolean. upstream_default: 'on'.

LinkLights

Link the key lights to the backlight? Optional. Type boolean. upstream_default: 'on'.

LircFlushThreshold

Threshold in microseconds of the gap that triggers flushing the data to lirc If LircTime_us is on values greater than 32.767ms will disable the flush If LircTime_us is off values greater than 1.999938s will disable the flush. Optional. Type integer. upstream_default: '8000'.

LircHost

Host name or address of the instance that is to receive codes If not set, or set to an empty value, support is disabled. Optional. Type uniline. upstream_default: '127.0.0.1'.

LircPort

port on which is listening Optional. Type integer. upstream_default: '8765'.

LircTime_us

data time unit for On: times sent in microseconds (requires driver that accepts this). Off: times sent in 'jiffies' (1/16384s) (supported by standard driver). Optional. Type boolean. upstream_default: 'off'.

OffBrightness

Set the brightness while the backlight is 'off' . Works only with the 20x4 device. Optional. Type integer. upstream_default: '0'.

SEE ALSO

*

cme