Copyright (c) 1992 Drew Eckhardt (email@example.com), March 28, 1992 %%%LICENSE_START(VERBATIM) Permission is granted to make and distribute verbatim copies of this manual provided the copyright notice and this permission notice are preserved on all copies. Permission is granted to copy and distribute modified versions of this manual under the conditions for verbatim copying, provided that the entire resulting derived work is distributed under the terms of a permission notice identical t...
NAMEuselib - load shared library
int uselib(const char *library);
Note: No declaration of this system call is provided in glibc headers; see NOTES.
DESCRIPTIONThe system call uselib() serves to load a shared library to be used by the calling process. It is given a pathname. The address where to load is found in the library itself. The library can have any recognized binary format.
RETURN VALUEOn success, zero is returned. On error, -1 is returned, and errno is set appropriately.
ERRORSIn addition to all of the error codes returned by open(2) and mmap(2), the following may also be returned:
- The library specified by library does not have read or execute permission, or the caller does not have search permission for one of the directories in the path prefix. (See also path_resolution(7).)
- The system-wide limit on the total number of open files has been reached.
- The file specified by library is not an executable of a known type; for example, it does not have the correct magic numbers.
CONFORMING TOuselib() is Linux-specific, and should not be used in programs intended to be portable.
NOTESThis obsolete system call is not supported by glibc. No declaration is provided in glibc headers, but, through a quirk of history, glibc versions before 2.23 did export an ABI for this system call. Therefore, in order to employ this system call, it was sufficient to manually declare the interface in your code; alternatively, you could invoke the system call using syscall(2).
In ancient libc versions, uselib() was used to load the shared libraries with names found in an array of names in the binary.
Since libc 4.3.2, startup code tries to prefix these names with "/usr/lib", "/lib" and "" before giving up. In libc 4.3.4 and later these names are looked for in the directories found in LD_LIBRARY_PATH, and if not found there, prefixes "/usr/lib", "/lib" and "/" are tried.
From libc 4.4.4 on only the library "/lib/ld.so" is loaded, so that this dynamic library can load the remaining libraries needed (again using this call). This is also the state of affairs in libc5.
glibc2 does not use this call.
Since Linux 3.15, this system call is available only when the kernel is configured with the CONFIG_USELIB option.