tv_grab_combiner (1)

Leading comments

Automatically generated by Pod::Man 4.09 (Pod::Simple 3.35)

Standard preamble:
========================================================================

(The comments found at the beginning of the groff file "man1/tv_grab_combiner.1p".)

NAME

tv_grab_combiner - Grab listings by combining data from several grabbers.

SYNOPSIS

tv_grab_combiner --help

tv_grab_combiner --configure [--config-file

]

tv_grab_combiner [--config-file

]
                 [--days N] [--offset N]
                 [--output ] [--quiet]

DESCRIPTION

Output and listings in format by combining data from several other grabbers.

First you must run tv_grab_combiner --configure to choose which grabbers you want to grab data with and how these grabbers should be configured.

Then you can run tv_grab_combiner with the --days and --offset options to grab data. Omitting these options will use the default values for these parameters for each grabber. Since these defaults differs between grabbers, you might end up with data for different periods of time for different channels.

OPTIONS

--configure Prompt for which grabbers to use, how these grabbers shall be configured and write the configuration file.

--config-file

Set the name of the configuration file, the default is ~/.xmltv/tv_grab_combiner.conf. This is the file written by --configure and read when grabbing.

--output

When grabbing, write output to rather than standard output.

--days N When grabbing, grab N days rather than 5.

--offset N Start grabbing at today + N days. N may be negative.

--quiet Suppress the progress-bar normally shown on standard error.

--version Show the version of the grabber.

--help Print a help message and exit.

ERROR HANDLING

If any of the called grabbers exit with an error, tv_grab_combiner will exit with a status code of 1 to indicate that the data is incomplete. If any grabber produces output that is not well-formed xml, the output from that grabber will be ignored and tv_grab_combiner will exit with a status code of 1.

ENVIRONMENT VARIABLES

The environment variable can be set to change where configuration files are stored. All configuration is stored in $HOME/.xmltv/.

AUTHOR

Mattias Holmlund, mattias -at- holmlund -dot- se.

BUGS