netkit-rlogin (1)

Leading comments

Copyright (c) 1983, 1990 The Regents of the University of California.
All rights reserved.

Redistribution and use in source and binary forms, with or without
modification, are permitted provided that the following conditions
are met:
1. Redistributions of source code must retain the above copyright
   notice, this list of conditions and the following disclaimer.
2. Redistributions in binary form must reproduce the above copyright
   notice, this list of conditions and the following ...

(The comments found at the beginning of the groff file "man1/netkit-rlogin.1".)

NAME

rlogin - remote login

SYNOPSIS

rlogin [-8EKLd [-e char ] ] [-i identity ] [-l username ] [-p port ] host

DESCRIPTION

Rlogin starts a terminal session on a remote host host

Rlogin first attempts to use the Kerberos authorization mechanism, described below. If the remote host does not supporting Kerberos the standard Berkeley rhosts authorization mechanism is used. The options are as follows:

-8

The -8 option allows an eight-bit input data path at all times; otherwise parity bits are stripped except when the remote side's stop and start characters are other than ^S/^Q .

-i

The -i option specifies the local user name to use for authentication with the remote rlogind server. This overrides the default which is the name of the user invoking rlogin

-l

The -l option specifies the name of the remote user to login as. This overrides the default which is the name of the user invoking rlogin

-E

The -E option stops any character from being recognized as an escape character. When used with the -8 option, this provides a completely transparent connection.

-K

The -K option turns off all Kerberos authentication. This option has no effect since Kerberos authentication is not available in this version.

-L

The -L option allows the rlogin session to be run in ``litout'' (see tty(4)) mode.

-d

The -d option turns on socket debugging (see setsockopt(2)) on the TCP sockets used for communication with the remote host.

-e

The -e option allows user specification of the escape character, which is ``~'' by default. This specification may be as a literal character, or as an octal value in the form \nnn.

-p

The -p option specifies the port to connect to. This overrides the default which is login

A line of the form ``<escape char>.'' disconnects from the remote host. Similarly, the line ``<escape char>^Z'' will suspend the rlogin session, and ``<escape char><delayed-suspend char>'' suspends the send portion of the rlogin, but allows output from the remote system. By default, the tilde (``~'') character is the escape character, and normally control-Y (``^Y'') is the delayed-suspend character.

All echoing takes place at the remote site, so that (except for delays) the rlogin is transparent. Flow control via ^S/^Q and flushing of input and output on interrupts are handled properly.

ENVIRONMENT

The following environment variable is utilized by rlogin

TERM

Determines the user's terminal type.

SEE ALSO

rsh(1)

HISTORY

The rlogin command appeared in BSD 4.2

BUGS

Rlogin will be replaced by telnet(1) in the near future.

More of the environment should be propagated.