rfcomm (1)

Leading comments

This program is free software; you can redistribute it and/or modify
it under the terms of the GNU General Public License as published by
the Free Software Foundation; either version 2 of the License, or
(at your option) any later version.

This program is distributed in the hope that it will be useful,
but WITHOUT ANY WARRANTY; without even the implied warranty of
MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
GNU General Public License for more details.

You should have recei...

(The comments found at the beginning of the groff file "man1/rfcomm.1".)

NAME

rfcomm - RFCOMM configuration utility

SYNOPSIS

rfcomm [ options ] < command > < dev >

DESCRIPTION

rfcomm is used to set up, maintain, and inspect the RFCOMM configuration of the Bluetooth subsystem in the Linux kernel. If no command is given, or if the option -a is used, rfcomm prints information about the configured RFCOMM devices.

OPTIONS

-h

Gives a list of possible commands.

-a

Prints information about all configured RFCOMM devices.

-r

Switch TTY into raw mode (doesn't work with "bind").

-i <hciX> | <bdaddr>

The command is applied to device hciX, which must be the name or the address of an installed Bluetooth device. If not specified, the command will be use the first available Bluetooth device.

-A

Enable authentification

-E

Enable encryption

-S

Secure connection

-M

Become the master of a piconet

-L <seconds>

Set linger timeout

COMMANDS

show <dev>

Display the information about the specified device.

connect <dev> [bdaddr] [channel]

Connect the RFCOMM device to the remote Bluetooth device on the specified channel. If no channel is specified, it will use the channel number 1. This command can be terminated with the key sequence CTRL-C.

listen <dev> [channel] [cmd]

Listen on a specified RFCOMM channel for incoming connections. If no channel is specified, it will use the channel number 1, but a channel must be specified before cmd. If cmd is given, it will be executed as soon as a client connects. When the child process terminates or the client disconnect, the command will terminate. Occurrences of {} in cmd will be replaced by the name of the device used by the connection. This command can be terminated with the key sequence CTRL-C.

watch <dev> [channel] [cmd]

Watch is identical to listen except that when the child process terminates or the client disconnect, the command will restart listening with the same parameters.

bind <dev> [bdaddr] [channel]

This binds the RFCOMM device to a remote Bluetooth device. The command does not establish a connection to the remote device, it only creates the binding. The connection will be established right after an application tries to open the RFCOMM device. If no channel number is specified, it uses the channel number 1.

release <dev>

This command releases a defined RFCOMM binding.
If all is specified for the RFCOMM device, then all bindings will be removed.

AUTHOR

Written by Marcel Holtmann <marcel@holtmann.org>.